Non-contact road condition detector

Non-contact road condition detector product introduction

Non-contact road condition detector uses remote sensing technology to avoid damage to the road and thus will not interfere with traffic caused by the installation of road weather stations. Multispectral measurement technology enables accurate detection of the thickness of ice, snow and water on road surfaces.

In road conditions where embedded road sensors are inconvenient or impossible to install, the FT-LM2 detector is the most ideal choice. Remote sensing installation means that there is no need to close the road or cut the road surface, and the installation work is safe and convenient. It requires little maintenance and is an ideal choice for road weather system components. It can be installed on existing weather stations or other buildings with unobstructed views from the road.

The Non-contact road condition detector is housed in an all-weather, durable housing to withstand the elements, allowing it to provide accurate data in any weather condition.

By providing road surface condition information, the FT-LM2 detector provides road management departments with accurate monitoring data and can take response measures before road safety dangers arise.

Non-contact road condition detector function

Detect water, snow and ice thickness on the road

Remote sensing to detect road conditions

Non-embedded installation is quick and easy

Low maintenance cost

Integrate into existing highway automatic weather monitoring network

Non-contact road condition detector application

Remote installation

bridge deck

Accident-prone areas

High traffic areas

Rain and snow prone areas

Non-contact road condition detector features

Measure road water, ice and snow from a distance

Measure road condition

Measure water, ice, and slipperiness

Non-embedded design

Anti-rust

Infrared detection up to 15 meters

No need to close lanes, easy installation and maintenance

Rugged design, all-weather measurement

Non-contact road condition detector main indicators

Note: Parameters marked with * are optional configurations and are not standard configurations.